What should we pay attention to when installing the road gate?
The most important thing in the parking lot is the traffic barrier system. If the parking lot barrier system is not installed properly, it will affect the normal operation of the entire parking lot. Therefore, it is very important to install the barrier system.
1. The barrier gate box must be installed firmly. It should be installed on a level ground without tilting. There should be no gaps when connecting to the ground. The barrier gate box should not exceed the lane line, ensuring a distance of about 5 cm.
2. When wiring the ground sense coil, it is best to put it in circles. Under normal circumstances, put 5 to 6 layers. The coils are pressed tightly between each layer. There must be no joints inside the coils, otherwise the barrier is prone to failure during use. resulting in failure to take off and land normally.
3. After connecting the ground sense wire, we need to check the ground sense to see if it is normal.
4. If we change the length of the gate pole of the parking lot, we should re-adjust the balance between the spring and the torque according to the length of the pole, otherwise it will cause overheating of the motor and wear of the gearbox.
