How to achieve the same way in and out of the roadway gate ?
How to achieve the same way in and out of the roadway gate
1. When there is no vehicle entering or going out at the entrance, both the entrance and exit are green lights, indicating that the vehicle can enter or exit by swiping the card; only when the vehicle enters the community must the swiping card be valid, the barrier gate can be opened, and the barrier gate will automatically fall when the car goes back , When the vehicle inside the community goes out, the barrier gate can be opened automatically only when the card is valid, and the gate will automatically close after the car is behind. The barrier gate has the function of preventing smashing cars;
2. When the imported vehicle first presses the imported vehicle detector: (that is, when the vehicle enters the direction first)
a. The exit immediately turns into a red light (before that it was a green light, as shown in the picture above), and internal vehicles are prohibited from going out, and the entrance is green. After the vehicle detector, the entrance will immediately turn into a red light, and the vehicle will continue to pass after the entrance is prohibited; as shown in the figure below:
b. After the imported vehicles pass through the barrier gate, the barrier gate will automatically drop the bar. When the vehicle passes through the exit traffic light detector, the exit and entrance will return to green lights from the beginning;
3. When there is a vehicle going out at the exit and pressing on the exit vehicle detector before the entrance: (that is, when the vehicle goes out first).
a. The entrance turns into a red light immediately (both ends were green lights before), and external vehicles are prohibited from passing through the interior. When the vehicle swipe card is valid, the gate will automatically open. When the exit vehicle leaves the traffic light vehicle detector at the exit, the exit will also immediately Turning to a red light to stop subsequent vehicles from passing;
b. After the exit vehicles pass through the barrier gate, the barrier gate will automatically drop the bar. When the vehicle passes the entrance traffic light detector, the exit and entrance will return to green lights from the beginning;
4. The system has the functions of automatic reset and manual forced reset. When the intelligent guidance traffic lights misjudged that the vehicle has been in the entrance and exit channel for a long time due to special reasons (at this time, the entrance and exit are all red lights, and vehicles are strictly prohibited from entering and exiting), the system can be based on The system reset time set on site, automatically (or manual, remote control, etc.) reset the traffic lights at the entrance and exit, and reset the entrance and exit to the initial state of the green light
